Theben IPsecure Router KNX
Out of stock
*Router/interface/line coupler IP and KNX
*For data exchange between KNX and IP networks
*Display of power failures on the bus (KNX IP Service)
RM3,771.31
Out of stock
*Operating voltage : 12 ? 30 V DC
*Power supply: 12?30 V DC / PoE – IEEE 802.3af class 1_Type of connection Bus connection: KNX bus terminal| RJ45 for LAN
Brand
Theben
General Inquiries
There are no inquiries yet.
Related products
-
Controller, Lighting Control System
ABB Line Coupler
The KNX DALI gateway connects KNX to the DALI bus.
The gateway is a category I control
device with an integrated DALI power supply for the ECGs (electronic ballasts / electronic control gear).The device is a Single-Master Controller according to EN 62386 ed/1 and ed/2.
It is able to control DALI ECGs ed/1 and ed/2 -also mixed- but according to single-master controller it cannot support DALI-2 sensors like movement- and presence detectors, switches etc.
Described features are related to Firmware V3.1.3 or higher with DCA and ETS application 7310 most earlier delivered devices can be upgradedIt supports the switching and dimming of up to 64 ECGs in 16 groups and the control up to 16 scenes.
The 64 ECGs can be controlled individually or in groups. Error messages of individual ECGs or each connected lamp can be transmitted to the KNX and visualised.
SKU: LK/S 4.1 -
Controller, Lighting Control System
ABB Actuator 4 Fold
Uses potential free contacts to switch 4 independent electrical loads via the ABB i-bus?
Manual operation and display of the switching state of the contacts
The 10AX-AC1 device is especially suited for loads with high surge currents e.g. flourescent lighting (AX) acc. EN 60669.
SKU: SA/S 4.10.2.1 -
Controller, Lighting Control System
ABB Light Controller, 2-fold, 1-10 V
Device for switching and dimming two independent groups of luminaries with electronic ballasts (0 ? 10 V control input).
When combined with the light sensor LF/U 2.1 the device can be used as a 2-fold light controller for constant light control.
SKU: LR/S2.16.1 -
Controller, Lighting Control System
ABB Actuator 8 Fold
Uses potential free contacts to switch 8 independent electrical loads via the ABB i-bus?.
Manual operation and display of the switching state of the contacts.
The 10AX-AC1 device is especially suited for loads with high surge currents e.g. flourescent lighting (AX) acc. EN 60669.
SKU: SA/S 8.10.2.1
