KNX Bus Cable
Out of stock
Application as BUS cable in dry, damp and wet rooms, even outdoors, if protected from direct sunlight, but not in the ground. As a BUS cable for the European Installation Bus (EIB) or KNX approved. For fixed installation on, in and under plaster, also in pipes and ducts
RM500.00 – RM2,500.00
Standards : according DIN VDE 0815
Conductor material : Cu, bare
Conductor type : bare with single wire
Screening : aluminium-laminated foil
Outer sheath color : various
Bus type : EIB / KNX
Test voltage : 4000 V
Nominal voltage Uo/U : 250/250 V
Operating Capacity : (800Hz) max. 100 nF/km
Working peak voltage : 250 V
RoHS-compliant : yes
Bend radius : 10 x cable diameter
Loop resistance : max. 130 Ω/km
Brand
BOHM
Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
General Inquiries
There are no inquiries yet.
Related products
-
Controller, Lighting Control System
ABB Actuator 12 Fold
Uses potential free contacts to switch 12 independent electrical loads via the ABB i-bus?
Manual operation and display of the switching state of the contacts
The 10AX device is especially suited for loads with high surge currents e.g. flourescent lighting (AX) acc
EN 60669.
SKU: SA/S 12.10.1 -
Lighting Control System
KNX Push Button, 3-fold, White
Push Button Sensor Plus Series is a KNX push
button switch used to provide seamless
experience of KNX system. Frame is separately
purchased and is compatible with any European
standard 55mm frame. This series comes in either
white or black modules.
SKU: GC10PB003WH -
Controller, Lighting Control System
ABB Switch-/Dim Actuator, 8-fold, 16 A
MDRC Devices for switching and dimming of 2, 4 or 8 independent groups of luminaries with electrical ballasts and 1-10V control inputs.
Per channel a potential free relay can be switched on or off via the ABB i-bus? or manually.
Manual and visual operation is included.
A power supply is not necessary.
SKU: SD/S8.16.1 -
Controller, Lighting Control System
ABB Shutter Actuator 8 Fold
For the control of independent 230 V AC drives via ABB i-bus? KNX.
The devices are designed for positioning blinds, roller shutters, awnings and other shading products as well as for controlling doors, windows and ventilation flaps. Additional auxiliary voltage is not needed.
To protect the drives, the output contacts are electromechanically locked against each other.
Push buttons are located at the front of the device to control the outputs e.g. during commissioning.
The current status of the output is displayed via LEDs.
SKU: JRA/S 8.230.1.1
There are no reviews yet.