KNX Power supply 640 mA
Greencontrols KNX Power Supply Unit generates and monitors KNX system voltage. It also comes with an additional 30V DC Auxiliary voltage terminal.
RM1,156.70
Operating Voltage: 199 – 255 VAC ? 10%
KNX Output: 30V DC ?2V, with integrated choke
Auxiliary Output: 30V DC ?1V, without integrated choke
KNX Nominal Current: 640mA
Operation/ display:
Red LED1 Reset the KNX bus
GreenLED2 Normal Operation
Red LED3 Overload/short circuit(I>Imax)
Yellow LED4 Current level1 0= Yellow LED5 Current level2 160= Yellow LED6 Current level3 320= Yellow LED7 Current level4 640= Temperature: operation: -5C …. +45C Storage: -25C …. +55C Transport: -25C …. +70C
Brand
Greencontrols
General Inquiries
There are no inquiries yet.
Related products
-
Controller, Lighting Control System
ABB Light Controller, 2-fold, 1-10 V
Device for switching and dimming two independent groups of luminaries with electronic ballasts (0 ? 10 V control input).
When combined with the light sensor LF/U 2.1 the device can be used as a 2-fold light controller for constant light control.
SKU: LR/S2.16.1 -
Controller, Lighting Control System
ABB Switch-/Dim Actuator, 8-fold, 16 A
MDRC Devices for switching and dimming of 2, 4 or 8 independent groups of luminaries with electrical ballasts and 1-10V control inputs.
Per channel a potential free relay can be switched on or off via the ABB i-bus? or manually.
Manual and visual operation is included.
A power supply is not necessary.
SKU: SD/S8.16.1 -
Controller, Lighting Control System
ABB Line Coupler
The KNX DALI gateway connects KNX to the DALI bus.
The gateway is a category I control
device with an integrated DALI power supply for the ECGs (electronic ballasts / electronic control gear).The device is a Single-Master Controller according to EN 62386 ed/1 and ed/2.
It is able to control DALI ECGs ed/1 and ed/2 -also mixed- but according to single-master controller it cannot support DALI-2 sensors like movement- and presence detectors, switches etc.
Described features are related to Firmware V3.1.3 or higher with DCA and ETS application 7310 most earlier delivered devices can be upgradedIt supports the switching and dimming of up to 64 ECGs in 16 groups and the control up to 16 scenes.
The 64 ECGs can be controlled individually or in groups. Error messages of individual ECGs or each connected lamp can be transmitted to the KNX and visualised.
SKU: LK/S 4.1 -
Controller, Lighting Control System
Schneider KNX SPACELYNK LOGIC CONTROLLER
Logic Controller
spaceLYnk is the easiest way to build a complete Building Automation Solutions for commercial segments :
_ Complete Building Automation solution for Small and Medium building with a complete architecture including Light and Room Control (KNX, DALI Control), Metering (Modbus offer, Smartlink RTU and IP), and boiler management (SSL)
_ Complete Building Automation solution for Large Building with a complete architecture managed by SBO (BMS from Schneider Electric) and including Light and Room Control (KNX, DALI Control) and Metering (Modbus offer, Smartlink RTU and IP)SKU: so-sch-4
