Schneider KNX Push-button Pro, polar white, glossy, System M
Out of stock
* a push-button panel with a programmable number of buttons
*You can activate a maximum of four touch surfaces to which you can assign the desired room functions, e.g. switching or dimming light, controlling blinds or calling up scenes
*If required, you can disable the touch surfaces and also define the type of disabling
RM300.50
Out of stock
Power supply from KNX: DC 24 V, approx. 20 mA
Ambient operating temperature: -5 ?C to +45 ?C
Max. humidity: 93% relative humidity, no condensation
Environment: The device is designed for use at elevations up to 2000
m above sea level
IP protection rating: IP 20
KNX connection: Two 1 mm pins for bus connecting terminal
Dimensions: 55 mm x 55 mm (HxW)
Brand
Schneider
General Inquiries
There are no inquiries yet.
Related products
-
Controller, Lighting Control System
Schneider Push-button interface, 4-gang plus
Generates an internal signal voltage for connecting four conventional push-buttons or floating contacts, and for direct connecting four low-current LEDs
The cores are 30 cm long and can be extended to max. 7.5 m. For installation in a conventional 60 mm switch box.
SKU: so-sch-5 -
Controller, Lighting Control System
ABB Shutter Actuator 8 Fold
For the control of independent 230 V AC drives via ABB i-bus? KNX.
The devices are designed for positioning blinds, roller shutters, awnings and other shading products as well as for controlling doors, windows and ventilation flaps. Additional auxiliary voltage is not needed.
To protect the drives, the output contacts are electromechanically locked against each other.
Push buttons are located at the front of the device to control the outputs e.g. during commissioning.
The current status of the output is displayed via LEDs.
SKU: JRA/S 8.230.1.1 -
Controller, Lighting Control System
ABB Shutter Actuator 4 Fold
For the control of independent 230 V AC drives via ABB i-bus? KNX
The devices are designed for positioning blinds, roller shutters, awnings and other shading products as well as for controlling doors, windows and ventilation flaps.
Additional auxiliary voltage is not needed. To protect the drives, the output contacts are electromechanically locked against each other.
Push buttons are located at the front of the device to control the outputs e.g. during commissioning.
The current status of the output is displayed via LEDs.
SKU: JRA/S 4.230.1.1 -
Controller, Lighting Control System
ABB Light Controller, 2-fold, 1-10 V
Device for switching and dimming two independent groups of luminaries with electronic ballasts (0 ? 10 V control input).
When combined with the light sensor LF/U 2.1 the device can be used as a 2-fold light controller for constant light control.
SKU: LR/S2.16.1
