Theben PS 640 mA T KNX
Out of stock
Power-supplying and monitoring of the KNX system voltage,640 mA supply voltage,30 V DC auxiliary supply,Reset key for 20 sec. bus reset,Continuous short-circuit protection
RM1,558.35
Out of stock
Operating voltage : 230 _ 240 V AC 50 _ 60 Hz, KNX output : 1 line with integrated throttle drive, Nominal current KNX : 640 mA, Certification : KNX Certified
Brand
Theben
General Inquiries
There are no inquiries yet.
Related products
-
Lighting Control System, Power Supply
Schneider KNX power supply REG-K/640 mA, light grey
For generating the bus voltage for a line with up to 64 bus devices.
With integrated choke to decouple the power supply from the bus and a push button to disconnect the power and reset the bus devices connected to the line.
For installation on DIN rails TH35 according to EN 60715.
The bus is connected using a bus connecting terminal; a data rail is not necessary.
SKU: so-sch-1 -
Gateway, Lighting Control System
Schneider KNX DALI gateway REG-K/1/16(64)/64/IP1
The KNX DALI gateway connects KNX to the DALI bus.
The gateway is a category I control device with an integrated DALI power supply for the ECGs (electronic ballasts / electronic control gear).
The device is a Single-Master Controller according to EN 62386 ed/1 and ed/2.
It is able to control DALI ECGs ed/1 and ed/2 -also mixed- but according to single-master controller it cannot support DALI-2 sensors like movement- and presence detectors, switches etc.
Described features are related to Firmware V3.1.3 or higher with DCA and ETS application 7310 most earlier delivered devices can be upgraded
It supports the switching and dimming of up to 64 ECGs in 16 groups and the control up to 16 scenes.The 64 ECGs can be controlled individually or in groups.
Error messages of individual ECGs or each connected lamp can be transmitted to the KNX and visualised.
SKU: so-sch-3 -
Controller, Lighting Control System
Schneider Blind/switch actuator REG-K/8x/16x/10 with manual mode
For independent control of up to 8 blind/roller shutter drives or for switching up to 16 loads via make contacts
The function of the blind or switching channels is freely configurable
All blind/switch outputs can be operated manually using push-buttons
SKU: so-sch-8 -
Controller, Lighting Control System
Schneider Switch actuator REG-K/12×230/10 with manual mode
For independent switching of up to 12 loads via make contacts
The function of the switching channels is freely configurable
All switching outlets can be operated manually using pushbutton operation
SKU: so-sch-7
