Schneider Push-button, 4-gang plus, anthracite, System M
Out of stock
The push-buttons can be set to perform various functions, allowing you, for example, to switch lighting on and off or dim it
control the blinds or retrieve stored scenes
Push-buttons with IR receiver also allow you to operate each key on the push-button using a Schneider remote control or another IR remote control.
RM1,285.90
Out of stock
Initialisation: Due to the telegram rate limit, telegrams can only be created after a minimum of 17 sec has elapsed since
initialisation.
Ambient temperature
Operation: -5 ?C to +45 ?C
Storage: -25 ?C to +55 ?C
Transport: -25 ?C to +70 ?C
Max. humidity: 93 % relative humidity, no moisture
condensation
Type of protection: IP 20
Brand
Schneider
General Inquiries
There are no inquiries yet.
Related products
-
Lighting Control System, Power Supply
ABB Power Supply 640mA
KNX power supplies 640 mA generate and monitor the KNX system voltage (SELV).
The bus line is decoupled from the power supply by an integrated choke.
The voltage output is short-circuit and overload protected.
The two-color LED indicates device output status.
Device type SV/S 30.640.3.1 has an additional 30 V DC short-circuit and overload protected voltage output that can be used to power an additional bus line (in combination with a separate choke).
With two-coloured status indicator and wide range input from 85?265 V AC, 50/60 Hz.
SKU: SV/S 3.640.3.1 -
Lighting Control System
KNX Push Button, 3-fold, White
Push Button Sensor Plus Series is a KNX push
button switch used to provide seamless
experience of KNX system. Frame is separately
purchased and is compatible with any European
standard 55mm frame. This series comes in either
white or black modules.
SKU: GC10PB003WH -
Lighting Control System, Power Supply
Schneider KNX power supply REG-K/640 mA, light grey
For generating the bus voltage for a line with up to 64 bus devices.
With integrated choke to decouple the power supply from the bus and a push button to disconnect the power and reset the bus devices connected to the line.
For installation on DIN rails TH35 according to EN 60715.
The bus is connected using a bus connecting terminal; a data rail is not necessary.
SKU: so-sch-1
