Schneider Push-button, 4-gang plus, polar white, glossy, System M
Out of stock
n provides you with two, four or eight operating surfaces
two in the case of 1-gang pushbuttons
four in the case of 2-gang push-buttons, and eight in the case of 4-gang push-buttons
The push-buttons can be set to perform various functions, allowing you, for example, to switch lighting on and off or dim it, control the blinds or retrieve stored scenes
Push-buttons with IR receiver also allow you to operate each key on the push-button using a Schneider remote control or another IR remote contro
RM1,197.60
Out of stock
Initialisation: Due to the telegram rate limit, telegrams can only be created after a minimum of 17 sec has elapsed since
initialisation.
Ambient temperature
Operation: -5 ?C to +45 ?C
Storage: -25 ?C to +55 ?C
Transport: -25 ?C to +70 ?C
Max. humidity: 93 % relative humidity, no moisture
condensation
Type of protection: IP 20
Brand
Schneider
General Inquiries
There are no inquiries yet.
Related products
-
Controller, Lighting Control System
Schneider Blind/switch actuator REG-K/8x/16x/10 with manual mode
For independent control of up to 8 blind/roller shutter drives or for switching up to 16 loads via make contacts
The function of the blind or switching channels is freely configurable
All blind/switch outputs can be operated manually using push-buttons
SKU: so-sch-8 -
Gateway, Lighting Control System
Schneider KNX DALI gateway REG-K/1/16(64)/64/IP1
The KNX DALI gateway connects KNX to the DALI bus.
The gateway is a category I control device with an integrated DALI power supply for the ECGs (electronic ballasts / electronic control gear).
The device is a Single-Master Controller according to EN 62386 ed/1 and ed/2.
It is able to control DALI ECGs ed/1 and ed/2 -also mixed- but according to single-master controller it cannot support DALI-2 sensors like movement- and presence detectors, switches etc.
Described features are related to Firmware V3.1.3 or higher with DCA and ETS application 7310 most earlier delivered devices can be upgraded
It supports the switching and dimming of up to 64 ECGs in 16 groups and the control up to 16 scenes.The 64 ECGs can be controlled individually or in groups.
Error messages of individual ECGs or each connected lamp can be transmitted to the KNX and visualised.
SKU: so-sch-3 -
Controller, Lighting Control System
ABB Shutter Actuator 4 Fold
For the control of independent 230 V AC drives via ABB i-bus? KNX
The devices are designed for positioning blinds, roller shutters, awnings and other shading products as well as for controlling doors, windows and ventilation flaps.
Additional auxiliary voltage is not needed. To protect the drives, the output contacts are electromechanically locked against each other.
Push buttons are located at the front of the device to control the outputs e.g. during commissioning.
The current status of the output is displayed via LEDs.
SKU: JRA/S 4.230.1.1
