*perating voltage : 230 V AC 50 Hz
*Type of contact : NO contact, 16 A, 10 A
*Voltage output : 230 V AC, Voltage input : 1 ? 10 V
*Signal current input max. : 100 mA per channel
*Max. cable length : 500 m
No products in the cart.
Out of stock
*2-way 1-10 V control unit MIX
*Base module MIX
*Can be upgraded to maximum of 6 channels
*Switching and dimming of lighting circuits in combination with electronic ballasts (EBs and ballasts LED), With crossover switching to spare the relay contact
RM1,500.48
Out of stock
*perating voltage : 230 V AC 50 Hz
*Type of contact : NO contact, 16 A, 10 A
*Voltage output : 230 V AC, Voltage input : 1 ? 10 V
*Signal current input max. : 100 mA per channel
*Max. cable length : 500 m
There are no inquiries yet.
For generating the bus voltage for a line with up to 64 bus devices.
With integrated choke to decouple the power supply from the bus and a push button to disconnect the power and reset the bus devices connected to the line.
For installation on DIN rails TH35 according to EN 60715.
The bus is connected using a bus connecting terminal; a data rail is not necessary.
Push Button Sensor Plus Series is a KNX push
button switch used to provide seamless
experience of KNX system. Frame is separately
purchased and is compatible with any European
standard 55mm frame. This series comes in either
white or black modules.
For controlling DALI devices via the ABB i-bus?
One DALI output for up to 64 DALI slaves. DALI power supply is integrated
Control and status feedback is carried out via KNX per DALI slave (64), with lighting groups (16), together in broadcast or per scenes (16)
Extensive fault and error messages are available Self-contained emergency converter (64) acc. EN 62386-202 will be supported
By means of KNX and emergency converter different emergency tests (e.g. function and duration test) can be triggered
Feedback is sent. Slave-, staircase-, force-, block- and scene- function are integrated. DALI telegram rate can change.
The KNX DALI gateway connects KNX to the DALI bus.
The gateway is a category I control
device with an integrated DALI power supply for the ECGs (electronic ballasts / electronic control gear).
The device is a Single-Master Controller according to EN 62386 ed/1 and ed/2.
It is able to control DALI ECGs ed/1 and ed/2 -also mixed- but according to single-master controller it cannot support DALI-2 sensors like movement- and presence detectors, switches etc.
Described features are related to Firmware V3.1.3 or higher with DCA and ETS application 7310 most earlier delivered devices can be upgraded
It supports the switching and dimming of up to 64 ECGs in 16 groups and the control up to 16 scenes.
The 64 ECGs can be controlled individually or in groups. Error messages of individual ECGs or each connected lamp can be transmitted to the KNX and visualised.