Schneider Switch actuator REG-K/12×230/10 with manual mode
Out of stock
For independent switching of up to 12 loads via make contacts
The function of the switching channels is freely configurable
All switching outlets can be operated manually using pushbutton operation
RM3,744.00
Out of stock
Power supply:
Nominal voltage: AC 230 V, 50 – 60 Hz
External auxiliary voltage (optional): AC 110 – 240 V, 50 – 60 Hz, max. 2 VA
For each switch output:
Nominal current: 10 A, cos_ = 1; 10 A, cos_ = 0.6
Incandescent lamps: AC 230 V, max. 2000 W
Halogen lamps: AC 230 V, max. 1700 W
Fluorescent lamps: AC 230 V, max. 1800 W, uncompensated
AC 230 V, max. 1000 W parallel-compensated
Capacitive load: AC 230 V, max. 105 ?F
Device width: 6 modules = approx. 108 mm
Contents: With bus connecting terminal and cable cover.
Brand
Schneider
General Inquiries
There are no inquiries yet.
Related products
-
Controller, Lighting Control System
ABB Light Controller, 4-fold, 1-10 V
Device for switching and dimming four independent groups of luminaries with electronic ballasts (0 ? 10 V control input).
When combined with the light sensor LF/U 2.1 the device can be used as a 4-fold light controller for constant lightcontrol.
SKU: LR/S4.16.1 -
Controller, Lighting Control System
ABB Actuator 8 Fold
Uses potential free contacts to switch 8 independent electrical loads via the ABB i-bus?.
Manual operation and display of the switching state of the contacts.
The 10AX-AC1 device is especially suited for loads with high surge currents e.g. flourescent lighting (AX) acc. EN 60669.
SKU: SA/S 8.10.2.1 -
Controller, Lighting Control System
ABB Actuator 12 Fold
Uses potential free contacts to switch 12 independent electrical loads via the ABB i-bus?
Manual operation and display of the switching state of the contacts
The 10AX device is especially suited for loads with high surge currents e.g. flourescent lighting (AX) acc
EN 60669.
SKU: SA/S 12.10.1 -
Controller, Lighting Control System
ABB Shutter Actuator 4 Fold
For the control of independent 230 V AC drives via ABB i-bus? KNX
The devices are designed for positioning blinds, roller shutters, awnings and other shading products as well as for controlling doors, windows and ventilation flaps.
Additional auxiliary voltage is not needed. To protect the drives, the output contacts are electromechanically locked against each other.
Push buttons are located at the front of the device to control the outputs e.g. during commissioning.
The current status of the output is displayed via LEDs.
SKU: JRA/S 4.230.1.1
