Theben theMova S360-101 DE WH
Out of stock
Passive infra-red motion detector for ceiling installation, Automatic motion and brightness-dependent control for lighting and HVAC, Channel A light: relay, 230 V, Channel H, presence: relay, floating e.g. for HVAC control
RM313.85
Out of stock
Operating voltage:230 V AC,Frequency:50 Hz, Installation height:2 ? 4 m, Stand-by consumption: ~0.5 W, Setting range brightness:30 ? 3000 lx, Light switch-off delay :10 s – 60 min, Type of contact light:Relay 230 V/10 A ?-contact, Detection range :50 m_ (? 8 m | 360?)
Brand
Theben
General Inquiries
There are no inquiries yet.
Related products
-
Controller, Lighting Control System
ABB Actuator 8 Fold
Uses potential free contacts to switch 8 independent electrical loads via the ABB i-bus?.
Manual operation and display of the switching state of the contacts.
The 10AX-AC1 device is especially suited for loads with high surge currents e.g. flourescent lighting (AX) acc. EN 60669.
SKU: SA/S 8.10.2.1 -
Controller, Lighting Control System
Schneider Blind/switch actuator REG-K/8x/16x/10 with manual mode
For independent control of up to 8 blind/roller shutter drives or for switching up to 16 loads via make contacts
The function of the blind or switching channels is freely configurable
All blind/switch outputs can be operated manually using push-buttons
SKU: so-sch-8 -
Gateway, Lighting Control System
Schneider KNX DALI gateway REG-K/1/16(64)/64/IP1
The KNX DALI gateway connects KNX to the DALI bus.
The gateway is a category I control device with an integrated DALI power supply for the ECGs (electronic ballasts / electronic control gear).
The device is a Single-Master Controller according to EN 62386 ed/1 and ed/2.
It is able to control DALI ECGs ed/1 and ed/2 -also mixed- but according to single-master controller it cannot support DALI-2 sensors like movement- and presence detectors, switches etc.
Described features are related to Firmware V3.1.3 or higher with DCA and ETS application 7310 most earlier delivered devices can be upgraded
It supports the switching and dimming of up to 64 ECGs in 16 groups and the control up to 16 scenes.The 64 ECGs can be controlled individually or in groups.
Error messages of individual ECGs or each connected lamp can be transmitted to the KNX and visualised.
SKU: so-sch-3 -
Lighting Control System, Power Supply
ABB Power Supply 640mA
KNX power supplies 640 mA generate and monitor the KNX system voltage (SELV).
The bus line is decoupled from the power supply by an integrated choke.
The voltage output is short-circuit and overload protected.
The two-color LED indicates device output status.
Device type SV/S 30.640.3.1 has an additional 30 V DC short-circuit and overload protected voltage output that can be used to power an additional bus line (in combination with a separate choke).
With two-coloured status indicator and wide range input from 85?265 V AC, 50/60 Hz.
SKU: SV/S 3.640.3.1
