Theben thePrema P360 KNX UP WH
Out of stock
KNX Passive infrared presence detector for ceiling mounting, Square detection range of 360? (up to 100 m2) for safe and easy planning, 3 channel light and 2 channel presence, 2 channel light C1, C2 with 2 light measurements and additional lighting channel C3 without brightness factor, Adaptable 3 channel light measurement
RM1,973.30
Out of stock
Installation height : 2 ? 10 m, Measuring range brightness : 5 ? 3000 lx,Detection angle : 360?, Installation type: Ceiling installation, Light switch-off delay: 30 s ? 60 min, Presence switch-off delay : 10 s – 120 min, Detection range : 81 m_ (9,0 x 9,0 m)
Brand
Theben
General Inquiries
There are no inquiries yet.
Related products
-
Lighting Control System
Switching Actuator – 12 channels, 20A, with Current Detection
The 12-Channel switching actuator is designed for
installation in distribution board and is suitable for
switching resistive loads and 12 independent
electric loads via floating contacts. It is built-in with
a mechanical bypass button which can be switch
ON/OFF manually. Each output is parameterized
via the ETS software
SKU: GC04SA006 -
Lighting Control System
KNX Push Button, 3-fold, White
Push Button Sensor Plus Series is a KNX push
button switch used to provide seamless
experience of KNX system. Frame is separately
purchased and is compatible with any European
standard 55mm frame. This series comes in either
white or black modules.
SKU: GC10PB003WH -
Lighting Control System
Switching Actuator – 8 channels, 20A, with Current Detection
The 8-Channel switching actuator is designed for
installation in distribution board and is suitable for
switching resistive loads and 8 independent electric
loads via floating contacts. It is built-in with a
mechanical bypass button which can be switch
ON/OFF manually. Each output is parameterized
via the ETS software
SKU: GC04SA005 -
Gateway, Lighting Control System
Schneider KNX DALI gateway REG-K/1/16(64)/64/IP1
The KNX DALI gateway connects KNX to the DALI bus.
The gateway is a category I control device with an integrated DALI power supply for the ECGs (electronic ballasts / electronic control gear).
The device is a Single-Master Controller according to EN 62386 ed/1 and ed/2.
It is able to control DALI ECGs ed/1 and ed/2 -also mixed- but according to single-master controller it cannot support DALI-2 sensors like movement- and presence detectors, switches etc.
Described features are related to Firmware V3.1.3 or higher with DCA and ETS application 7310 most earlier delivered devices can be upgraded
It supports the switching and dimming of up to 64 ECGs in 16 groups and the control up to 16 scenes.The 64 ECGs can be controlled individually or in groups.
Error messages of individual ECGs or each connected lamp can be transmitted to the KNX and visualised.
SKU: so-sch-3
